Contact person:
Shi Guoxi (General Manager) Tel: 13884663303
Wang Hongzhan (sales manager): 18865577323
Telephone\/Fax: 0535—6371732
Email:sdytruixing@163.com
Address: No. 10, Xiamen Street, Development Zone, Yantai City, Shandong Province
How to adjust the automatic sampler
The automatic sampler adopts a maintenance-free design. It can operate for a long time without any additional maintenance and cannot be blocked by waste fuses, detonating tubes, packaging bags, steel wires and other debris, and it does not leak. The machine and equipment must be calibrated before use. This is an important step. If used properly, it is very beneficial to the normal operation of the equipment. Next, the editor will briefly introduce to you the calibration method of the equipment.
After assembly, the equipment can be calibrated and tested after the electrode cables are connected according to the requirements and checked for accuracy. By manually turning the machine, you should be able to easily adjust the sampling spoon to the middle position, and then turn on the main switch. At this moment The power switch is on, and the PLC system control knob is placed in the RUN position. After 10 seconds, the motor runs. At this time, the sampling spoon of the automatic sampler should run in the direction away from the transmission mechanism (motor), or a person can stand on the side of the motor to check whether the motor should Run counterclockwise, otherwise, exchange the two cables connecting the motor. When adjusting the motor electrode connection line, be sure to wait until the switching power supply circuit is turned off for 5 minutes, and the indicator light of the frequency converter goes out. The direction adjustment is done. Then it can be put into trial operation. When the sampling spoon runs to one side and pauses, its parking position should be at the gap outside the sampling section to ensure that no slurry enters after the sampling spoon pauses to one side. It can be adjusted according to the assembly position of the sensor. The docking position of the sampling spoon. The vertical placement position of the sensor and controller should be between 2-4mm.
Our company is the main manufacturer of automatic sampling machines and has rich management experience. We are willing to do our best to help you deal with the situation and problems of product categories, and spare no effort to effectively control costs and expenses for you, creating a win-win situation together!
Previous: Flotation automatic dosing machine manufacturer|Copper oxide flotation activator
下一条: Common faults before using the automatic dosing machine
Related Industry Knowledge
- Advantages of using diaphragm pump dosing machine
- Structure and technical characteristics of automatic dosing machine
- Specific application of automatic ball adding machine
- Mine electronic belt scale assembly steps
- The reason why solenoid valve dosing machines are often used in the flotation process
- Introduction to dosing locations of peristaltic pump dosing machines
- Specific technical characteristics of flotation automatic dosing machine
- Introduction to the basic principles of spiral scale application
- How to modify the automatic lubrication system of ball mill?
- Advantages and installation and commissioning of automatic sampling machines
- Flotation automatic dosing machine manufacturer|Copper oxide flotation activator
- Solenoid valve dosing machine manufacturer|main work flow of mineral processing plant
- How to choose the dosing address and method for peristaltic pump dosing machine?
- Flotation automatic dosing machine usage standards
- Routine maintenance and upkeep of automatic dosing machine
- The dosing sequence of the flotation automatic dosing machine is determined in this way
- Basic functions of automatic dosing machine
- The main work flow of mineral processing - automatic dosing machine manufacturer
- Drug preparation and automatic dosing machine
- Advantages and corrosion-resistant design features of solenoid valve dosing machine