Solenoid valve dosing machine types and installation matters

Solenoid valve dosing machine types and installation matters:

Typical solenoid valve

Internal thread steam solenoid valve

Model specifications: ZQDF

Caliber: small diameter

Material: carbon steel, cast iron, stainless steel

Flange steam solenoid valve

Model specifications: ZQDF

Caliber: small diameter

Material: carbon steel, cast iron, stainless steel

ZCM gas solenoid valve

Model specifications:ZCM

Caliber: small diameter, medium diameter

Material: carbon steel, stainless steel

Solenoid valve (normally closed)

Model specifications: US-F

Caliber: small diameter, medium diameter

Material: carbon steel

Special solenoid valve for water

　　Solenoid valve dosing machineThe precautions for installing the solenoid valve are as follows:

When installing, please note that the arrow on the valve body should be in the same direction as the material. It should not be installed in areas with direct leakage or water seepage. The solenoid valve should be installed vertically upward.

The solenoid valve should ensure normal operation within the power supply voltage fluctuation area of ​​15%-10% of the rated voltage.

After the solenoid valve is installed, there must be no reverse pressure difference in the pipeline. It must be plugged in several times to warm it up before it can be put into use.

The pipeline must be fully cleaned before the solenoid valve is installed. The incoming substances should be free of impurities. A filter device should be installed in front of the valve.

When the solenoid valve has a problem or is cleaned, a bypass device should be installed to ensure that the system can operate again.