Automatic ball adding machine technical standards

1. Improve the structure of the ball storage bin

in the pastAutomatic ball adding machineThe exit of the ball bin is funnel-shaped, but due to the uncertainty of the position of the steel balls in the ball bin, two steel balls are stuck at the exit of the ball bin at the same time, and the forward thrust of the steel balls in the ball bin causes vibration to eliminate the stuck balls. Unsuccessful situation.

The outlet of the ball bin of our automatic ball adding machine is designed as an open square outlet, that is, the barrier-free design from the ball loading port to the exit of the ball bin allows the steel balls to smoothly reach the ball bin outlet from the inclined plate at the bottom of the ball bin. When the ball jam occurs, turn on the vibrator and increase the vibration force by loosening the ball plate to displace the steel ball and eliminate the ball jam.

2. Improve the ball control baffle in the ball warehouse

When loading balls into the ball bin of the automatic ball adding machine at one time, there are a large number of steel balls, which are very easy to accumulate at the outlet of the ball bin, and the steel balls are stuck at the ball outlet due to the pressure caused by the steel balls themselves.

To solve this problem, our company has raised the ball control baffle on the upper part of the ball warehouse outlet to maintain 1-2 layers of steel balls from the front of the ball warehouse to the exit. This can effectively avoid the backlog caused by too many steel balls. .

3. Lifting ball loosening device at the bottom of the ball bin

Because the friction on the surface of the steel ball is relatively large, when the steel ball narrows from wide to narrow, the friction will suddenly increase and even the ball may get stuck.

To solve this problem, our company raised the bin wall vibrator at the position where the bottom end of the ball bin sharply narrows. The bottom end of the ball bin is connected to the bin wall vibrator. When a jammed ball is detected, the vibrating movable plate of the bin wall vibrator is opened to produce an up and down 2mm The range of movement can loosen the ball and eliminate the effect of ball jamming.

4. Lift protective panels on both sides of the ball bin exit

There are protective plates on both sides of the outlet of the ball bin of the automatic ball adding machine. The gap is much smaller than the diameter of the steel ball, which can avoid ball leakage.