How can the automatic sampler be adjusted?

　　automatic samplerIt adopts protection-free formula, has a long operation time, does not need protection, is not blocked by waste fuses, detonation tubes, woven bag nets and other impurities, and does not seep water. The following is an explanation of the sampler adjustment process.

After the automatic sampling machine is installed, the adjustment and commissioning of the equipment must be carried out according to the wiring requirements and verified to be correct. Manually open the gate, the sampling spoon should be easily moved to an easy position, and then turn off the main switch. , the indicator light is on. At this time, the PLC control button is in the operating position. After the motor has been running for ten decades, the sampling spoon should then run in a direction away from the conduction mechanism (motor), or stand aside from the motor. The motor should run counterclockwise. , otherwise, connect the two cables of the motor button. When adjusting the motor wiring, be sure to wait until the power is turned off for 5 minutes and the inverter power indicator light turns off. After adjusting the position, you can put it into trial operation. When the sampling spoon ends to one end During operation, its docking part should be in the space outside the sampling interval to ensure that no pulp enters after the sampling spoon terminates its operation. By adjusting the installation position of the sensor, the docking part of the sampling spoon can be adjusted. The sensor and control panel should be placed vertically Between 2-4 mm.